The Cord Cover Trick That Hides Every Ugly Wire

What You'll Need

• Cord cover channel kit (white, about 39 inches, with a snap-on lid): $8-$12. Choose a fabric or plastic kit that does not come with its own permanent adhesive backing.
• Removable adhesive strips (large, rated for painted walls): $6-$8 per pack.
• Rubbing alcohol and a soft cloth: about $3, or use what you already own.
• Scissors or a small hand saw to trim the channel to length: free if you have them.
• Optional: cord clips or Velcro ties to bundle wires neatly: $4-$5.

How to Do It

1. Map the path your cords take from the outlet to your device. Use the straightest, shortest route, ideally along a baseboard or corner. Nothing is attached yet, so this is fully reversible.
2. Clean the wall spots with rubbing alcohol and let them dry fully. This helps the strips hold and later release without residue.
3. Bundle the cords together with Velcro ties so they lie flat and tidy inside the channel.
4. Trim the cord channel to the length you need, using scissors or a small saw for plastic. Dry-fit it along your path first.
5. Stick removable adhesive strips to the back of the channel every 6-8 inches, then press the channel to the wall for 30 seconds. These strips pull off cleanly with a slow, stretching motion.
6. Snap the cords inside and close the lid. If you want it to blend in, choose a channel that matches your wall color or baseboard.
7. Remove at move-out by pulling each strip tab straight down, slowly, parallel to the wall. This leaves no residue or marks.