Install a Draft Stopper Door Threshold in 30 Minutes for $15
The difference between a seal that lasts and one that fails by February is a gap-free compression fit, so measure the daylight under your door before you buy.
![[#~image_alt_1~#]](/_next/image?url=https%3A%2F%2Fd3klpa3rfwubzz.cloudfront.net%2Fmedia%2FAPI%20Uploads%2FDIY%2F740c77a1381abb00dbf03ac2ad3904d1_d41001872b.jpg&w=1920&q=75)
I used to stuff a rolled towel against our back door every December and call it a fix. The real culprit was a worn threshold with a quarter-inch gap, and warm air leaves through gaps that size faster than you'd think. A seal lasts or fails based on one variable: compression. The sweep has to touch the threshold along its entire width with light, even pressure. Too loose and air whistles through, too tight and the door drags and the vinyl tears within weeks. Get the height right and the seal holds for years. This whole project takes about 30 minutes for $15, and the only tools are a hacksaw, a drill, and a tape measure. Your furnace gets a break right away.
What You'll Need
- Materials (~$15 total):
- Aluminum door threshold with replaceable vinyl insert, 36-inch (~$10)
- Adhesive-backed door bottom sweep, 36-inch (~$4)
- Four to six 1-inch wood screws (included or ~$1)
- Tools (already on hand):
- Tape measure
- Hacksaw or fine-tooth metal blade
- Drill with 1/8-inch bit and Phillips bit
- Pencil and masking tape
- Rag and rubbing alcohol
How to Do It
- Measure the door width and the gap under it with the door closed. Knowing the gap tells you how tall a seal you need, and buying the wrong height is the top reason these fixes fail.
- Remove the old threshold or sweep by unscrewing it and prying gently. Leftover debris keeps the new piece from sitting flat, which creates the very gaps you're trying to close.
- Clean the sill with a rag and rubbing alcohol until it's dry and dust-free. Adhesive and screws both grip better on a clean surface, so the seal stays put.
- Cut the new threshold to fit, wrapping the cut line in masking tape first. The tape keeps the aluminum from chipping, and a snug end-to-end fit leaves no side gaps for air to find.
- Drill pilot holes with a 1/8-inch bit through the threshold's screw slots. Pilot holes stop the wood from splitting and keep the screws from stripping out.
- Screw the threshold down, centered under the closed door, tightening evenly. Even pressure keeps the surface level so the door seals across its full width.
- Attach the bottom sweep to the door, trimming to length and pressing it so it just brushes the threshold. That light contact is the compression that blocks drafts without dragging.
- Test by closing the door over a sheet of paper, or by turning off the lights and checking for daylight. If the paper slides out easily or light shows through, adjust the sweep down a hair.
Weatherization contractors use the dollar-bill test to check a seal: close the door on a bill and tug it. It should resist slightly all along the bottom edge. Test at the left, middle, and right, and if one spot slides freely, shim that section with a thin strip of foam tape under the threshold.















