Dollar Store Drawer Liners: The Trim Gap That Lies Flat
Cut the liner exactly to the drawer's width and it buckles when the wood swells; leave a small gap on every side and it stays flat for years.
![[#~image_alt_1~#]](/_next/image?url=https%3A%2F%2Fd3klpa3rfwubzz.cloudfront.net%2Fmedia%2FAPI%20Uploads%2FDIY%2F9512ab70f4bc1b0a3bcd2db13433c2e8_bba49856fd.jpg&w=1920&q=75)
I used to cut drawer liners to the exact inside measurement, and every one of them curled up within a month. Here is why: drawers are never perfectly square, and a liner cut edge to edge has nowhere to go when humidity shifts or the wood moves slightly. It rides up at the corners and snags every time you open the drawer. The fix is one tiny step: trim each liner about 1/8 inch smaller than the drawer floor on every side. That gap lets the liner sit flat, lets you lift it out to wash, and gets you a clean, custom-fit look for around $6 total, using dollar store foam board and peel-and-stick contact paper.
What You'll Need
- Dollar store foam board, 2 sheets, about $2
- Peel-and-stick contact paper, 1 roll in a pattern you like, about $1.25
- Tape measure, one you already own
- Pencil and straightedge, a ruler or yardstick works
- Utility knife with a fresh blade, about $3 if you need one
- Scissors, for trimming the contact paper
- Dry microfiber cloth, for wiping the drawer
How to Build It
- Empty the drawer completely, then wipe the floor and corners with a damp cloth and let it dry fully.
- Measure the inside width and depth at the floor, not the top edge, since drawer sides often flare slightly.
- Subtract 1/4 inch from each measurement so you get a 1/8 inch gap on every side, and write both numbers down.
- Mark those dimensions on the foam board with a pencil and straightedge.
- Cut along the line with a utility knife, using two or three light passes instead of one hard push, and keep your free hand behind the blade.
- Cover the foam piece with contact paper, leaving about 1 inch extra on all sides. Peel the backing back slowly and smooth outward as you go.
- Fold the extra paper over the edges and press it down firmly. Snip the corners at an angle first so they don't bunch.
- Drop the liner into the drawer and check that it sits flat with a visible gap all around, then restock.
Pick a contact paper with a subtle pattern instead of a solid color, because small prints hide dust and any slight cutting wobble. For kitchen or bathroom drawers, wipe the liner with a damp cloth monthly, and swap in a fresh one yearly since the foam is cheap enough to replace.















