Build a Wooden Boot Jack in 1 Hour for $12
The notch angle and a grippy, non-slip base decide whether your boot jack grips the heel firmly or skids across the floor.
![[#~image_alt_1~#]](/_next/image?url=https%3A%2F%2Fd3klpa3rfwubzz.cloudfront.net%2Fmedia%2FAPI%20Uploads%2FDIY%2F2f6c17ccee9af7252c8a0508ead1fea1_d01f6cdaaf.jpg&w=1920&q=75)
Every winter, I used to hop around the front door tugging at snow-caked boots, wrecking heel counters and my balance. A boot jack fixes that, but the difference between one that works for years and one that slides away or snaps comes down to two things: a V-notch cut wide enough to cradle the heel without pinching, and a base that stays put on the floor. A cut that is too shallow lets the boot slip out mid-pull, and a bare wood bottom skates on tile or hardwood. A pine board, a handsaw, and rubber feet solve both. The whole build takes about 1 hour and costs $12, which makes it a great last-minute Christmas Eve gift or a post-holiday entryway upgrade.
What You'll Need
- Materials (~$12 total):
- One 1x8 pine board, 24 inches long (~$7)
- One 1x4 pine board, 10 inches long, for the heel riser (~$2)
- Four self-adhesive rubber feet, 3/4-inch (~$2)
- 1 1/4-inch wood screws, 4 count (~$1)
- Wood glue and a small amount of mineral oil or wax finish (on hand)
- Tools:
- Handsaw or jigsaw
- Drill with 1/8-inch pilot bit
- 120-grit sandpaper or a sanding block
- Pencil, tape measure, and a speed square
How to Do It
- Mark a 24-inch length on the 1x8 and a 10-inch length on the 1x4 with the speed square. Square lines give you clean cuts, which keep the pieces sitting flat and stable.
- Cut both boards with a handsaw or jigsaw, staying just outside your pencil lines. Cutting slightly long lets you sand to the exact line instead of ending up short.
- Trace a V-notch on one end of the long board: 3 inches wide at the edge, tapering to a 1 1/2-inch rounded point about 4 inches deep. This shape cradles the heel of most boots without pinching.
- Cut the notch with a jigsaw or handsaw, making two angled cuts toward the point. Round the inner point with a pencil-width drill hole first if you like, since it prevents splitting along the grain.
- Sand every edge and the notch interior until smooth, finishing with 120-grit. Rough edges snag laces and leave splinters in socks.
- Attach the short 1x4 riser under the far end of the long board with glue and two pilot-drilled screws. The riser tilts the board slightly so your foot has leverage, and pilot holes stop the pine from cracking.
- Finish with a thin coat of mineral oil or wax and let it soak in for 15 minutes. Sealing the wood keeps melted snow and salt from swelling the pine.
- Stick a rubber foot on each corner of the underside. Without grippy feet, the jack scoots away on tile and hardwood the moment you step on it. Test with a boot before gifting.
Professional shoemakers and bootmakers size heel cradles to the widest common heel, then add a slight bevel to the notch edges so leather never catches on a sharp corner. Run a pencil along both notch edges and sand a 45-degree chamfer. It protects boot finishes and makes the pull feel noticeably smoother.















